View Single Post
Old 08-24-2017, 01:46 PM   #24
Josh (PA)
Hello.
 
Josh (PA)'s Avatar
 
Join Date: Mar 2004
Carmudgeonly Ride: '09 X3, '11 328xiT, '11 135i C, '17 c2, '19 X5
Location: Downingtown, PA
Posts: 5,514
It should be a 20 min job roadside or in a parking spot without issue. The only tool needed is a socket to remove the engine cover. The coil latches swing open (be sure you swing them all the way vertical) and disconnect. There is a hole in the latch to put your finger through and pull them out. The plastic at the hole is a little sharp, so you may want some light gloves or a rag to displace the load a bit. pop the new ones in (be sure the rubber sleeve doesn't bunch at the top of the opening, snap the latch down and you're done. (at least that was how it was on the n54).
__________________
Josh (PA) -
'19 X5
'17 991.2 C2 Cab
'11 135i Convertible
'11 328xiT
'09 X3
Josh (PA) is offline   Reply With Quote