Oil Changes - BMW and making messes....lol
Hi everyone -
I have been doing oil changes in E38's for FOREVER and now have recently had a situation come up...
When being removed, the filter is not staying attached to the screw'd in cover so - when I go to remove the filter, the cover unscrews and leaves the filter seated in the housing not allowing the filter to drain.
As such - when the cover is clear of the housing - all the oil that is still trapped there spooges all over. I have to manually pull up the filter to allow the housing to drain.
I have had this happen a couple of times... The filter snaps into the cover ok (I guess) but the drag on the removal seems to overpower the retention on the cover. I placed a new filter on the cover and installed into the housing. I then remove the cover and the filter stayed seated in the housing.
I have been using Hengst filters for a while and have had this happen for the last 2 or 3 oil changes.
Thoughts? Any experiences with other brands?
Mahle, Bosch, Mann filters do better at this?
I may even get a new housing cover.... while the filter does seem to snap to the cover ok - maybe it is not 'ok enough' to overcome housing drag for pulling it up....
Either way - just wanted to see if any of you who wrench on your own cars have had any thoughts on this....
Thanks
__________________
Kevin
1970 2800CS - - 2001 740iL - - 2006 997.1 - - 2012 Escalade
1968 Mustang GT Convertible - - 2003 Ford F250 PSD - - 1985 728i
|